IMPORTANT NOTICE:
WARNING:
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: 1) This device may not
cause harmful interference, and 2) this device must accept any
interference received, including interference that may cause
undesired operation.
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Safety Information for microTALK Radios
Your wireless handheld portable transceiver contains a low power
transmitter. When the talk button is pushed, it sends out radio
frequency (RF) signals. The device is authorized to operate at a
duty factor not to exceed 50%. In August 1996, the Federal
Communications Commissions (FCC) adopted RF exposure
guidelines with safety levels for handheld wireless devices.
Important
FCC RF Exposure Requirements: For body-worn operation, this
radio has been tested and meets the FCC RF exposure
guidelines when used with Cobra accessories supplied or
designated for this product. Use of other accessories may not
ensure compliance with FCC RF exposure guidelines. Use only
the supplied antenna. Unauthorized antennas, modifications or
attachments could damage the transmitter and may violate FCC
regulations.
Normal Position:
Hold the transmitter approximately two (2) inches from your face
and speak in a normal voice, with the antenna pointed up and
away.
FCC Part 15.21 Warning Statement-
NOTE:
THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES
OR MODIFICATIONS NOT EXPRESSLY APPROVED BY THE PARTY
RESPONSIBLE FOR COMPLIANCE. SUCH MODIFICATIONS COULD
VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
IC RSS-GEN
This device complies with Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio excempts de licence.
L;exploitation est autorisée aux deux condtions suivantes:
(1) l’appariel ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible
d’en compromettre le fonctionnement.
Radiation Exposure Statement:
Under ISEDC regulations, this radio transmitter may only operate
using the antenna that is affixed to the radio transmitter. Use
only the supplied antenna. Unauthorized antennas,
modifications, or attachments could damage the transmitter and
may void the user’s authority to operate the radio.
Any changes of modifications not expressly approved by the
party responsible for compliance could void the user’s ability to
operate the equipment.
SAR tests are conducted using standard operating positions
accepted by the FCC/ISEDC with the device transmitting at its
highest certified power level in all tested frequency bands.
Although the SAR is determined at the highest certified power
level, the actual SAR level of the device while operating can be
well below the maximum value.
This device has been tested and certified to not exceed the
exposure limit established by the FCC/ISEDC. Tests for each
device are performed in positions and locations (e.g. at the ear
and worn on the body) as required by the FCC/ISEDC.
For body worn operation, this device has been tested and meets
the FCC/ISEDC RF exposure guidelines when used with an
accessory designated for this product or when used with an
accessory that contains no metal and that positions the handset a
minimum of 10mm from the body. Non-compliance with the
above restrictions may result in a violation of RF exposure
guidelines.
Product Service and Support
If you have any questions about operation or installing your new
Cobra product, PLEASE CONTACT COBRA FIRST…do not return
this product to any retail store.
The contact information for Cobra will vary depending on the
country in which you purchased and utilize the product. For the
latest contact information, please go to www.cobra.com/support
For products purchased in the U.S.A. you may call
800-543-1608.
For products purchased in the U.S.A., if your product should
require factory service, please go to www.cobra.com and follow
the instructions for returning your product to the Cobra Factory
Service Department for service.
Should there be any problems with this product or further
information is needed on its features please visit www.co-
bra.com for support, frequently asked questions, Declarations of
Conformity, and full manuals.
Trademark Acknowledgement
©2022 Cobra Electronics Corporation. Cobra and the snake
design are proprietary trademarks of Cobra Electronics
Corporation, USA. Other trademarks and trade names are those
of their respective owners.
Cobra Electronics Corporation™ is a trademark of Cobra
Electronics Corporation, USA.
Limited One-Year Warranty
Cobra warrants your product against all defects in materials and
workmanship for a period of one (1) year from the date of original
purchase.
Cobra, at our sole discretion, will repair or replace your product (with the
same or comparable product) free of charge.
Cobra will not pay shipping charges that you incur for sending your product
to us. Products received COD will be refused.
To make a warranty claim, we will require proof or purchase in the form of
an invoice or receipt. No proof of purchase is required for factory direct
purchases.
Warranty Exclusions: Warranty does not apply to your product under any of
the following conditions: 1. The serial number has been removed or
modified. 2. Your product has been subjected to misuse or damage
(including water damage, physical abuse, and/or improper installation). 3.
Your product has been modified in any way. 4. Your receipt or
proof-of-purchase is from a non-authorized dealer or internet auction site
including E-bay, U-bid, or other non-authorized resellers.
LIMITATION OF WARRANTY: EXCEPT AS EXPRESSLY PROVIDED HEREIN,
YOU ARE ACQUIRING THE PRODUCT “AS IS” AND “WHERE IS”, WITHOUT
REPRESENTATION OR WARRANTY. COBRA SPECIFICALLY DISCLAIMS ANY
REPRESENTATION OR WARRANTY INCLUDING, BUT NOT LIMITED TO THOSE
CONCERNING THE MERCHANTABILITY AND SUITABILITY OF THE PRODUCT
FOR A PARTICULAR PURPOSE. COBRA SHALL NOT BE LIABLE FOR
CONSEQUENTIAL, SPECIAL OR INCIDENTAL DAMAGES INCLUDING,
WITHOUT LIMITATION, DAMAGES ARISING OUT OF THE USE, MISUSE OR
MOUNTING OF THE PRODUCT.
The above limitations or exclusions shall be limited to the extent they
violate the laws of any particular state. Cobra is not responsible for
products lost in shipment between the owner and our service center.
General Warranty Information
Each product we manufacture is covered by our factory warranty. While each
product may have unique components and policy, the general guideline below
will apply to most Cobra products.
All Cobra products purchased factory-direct or from our Authorized
Resellers will come with a full one to three (1-3) year warranty from the
date of the original retail purchase (see policy statement above for full
warranty details and exclusions).
Standard accessories packaged with each model will have a one-year
factory warranty.
Accessory items have a one-year factory warranty.
Shipping to our facility is not covered in our warranty. Return shipping is
included within the US.
This warranty is non-transferrable.
For the sake of clarity, ‘repair or replace the Product or its defective part’
does not include removal or installation work, costs or expenses which
include but are not limited to labor costs or expenses.
Cobra will not be responsible for lost packages.
For Products Purchased Outside the U.S.A.
Please contact your authorized local reseller or agent for
warranty information.
CS30331
Energy Efficiency
Verified
User’s Guide
TWO-WAY RADIO MODEL
CX112
Printed in China, Part No. 814-CX1122-101
