background image

Operation

Warranty

Introduction

14

15

IMPORTANT NOTICE: FCC LICENSE REQUIRED 

This two-way radio operates on GMRS (General Mobile Radio Service) frequencies 
which require an FCC (Federal Communications Commission) license. A user must be 
licensed prior to operating on Channels 1 through 7 on high power or 15 through 
22, which comprise the GMRS channels of this radio. Serious penalties could result for 
unlicensed use of GMRS channels, in violation of FCC rules. Operation of this radio is 
subject to additional rules specified in 47 C.F.R. Part 95. 
Licensed users will be issued a call sign by the FCC, which should be used for station 
identification when operating this radio. GMRS users should also cooperate by engaging 
in permissible transmissions only, avoiding channel interference with other GMRS users, 
and being prudent with the length of their transmission time. 
For licensing information and application forms, please call the FCC Hotline  
at 800-418-FORM. Request form #159 and form #605. Questions regarding  
the license application should be directed to the FCC at 888-CALL-FCC.  
Additional information is available on the FCC’s website at www.fcc.gov.
Channel 1 through 7 on low power and channels 8 through 14 comprise the  
FRS (Family Radio Service). No license is required to operate on the FRS.

Safety Information for microTALK Radios

Your wireless handheld portable transceiver contains a low power transmitter.  
When the talk button is pushed, it sends out radio frequency (RF) signals.  
The device is authorized to operate at a duty factor not to exceed 50%.  
In August 1996, the Federal Communications Commissions (FCC) adopted  
RF exposure guidelines with safety levels for handheld wireless devices. 

Important

FCC RF Exposure Requirements: For body-worn operation, this radio has  
been tested and meets the FCC RF exposure guidelines when used with Cobra 
accessories supplied or designated for this product. Use of other accessories  
may not ensure compliance with FCC RF exposure guidelines. Use only the supplied 
antenna. Unauthorized antennas, modifications or attachments  
could damage the transmitter and may violate FCC regulations. 

Normal Position

Hold the transmitter approximately 2 inches from your face and speak in a normal 
voice, with the antenna pointed up and away.

The receiver for these two-way radios and the external power supply for 
charging comply with part 15 of the FCC Rules. Operation is subject  
to the following two conditions: 1) This device may not cause harmful 
interference, and 2) this device must accept any interference received, 
including interference that may cause undesired operation.
FCC Warnings: Replacement or substitution of transistors, regular diodes or 
other parts of a unique nature, with parts other than those recommended by 
Cobra may cause a violation of the technical regulations of part 95 of the FCC 
rules, or violation of type acceptance requirements of part 2 of the rules.

General Specifications 

 

 General Specifications  

and Licensing 

Customer Assistance

Operation

Nothing 

Comes Close to a Cobra

®

  FRS/GMRS Frequency  

Allocation and Compatibility

Important: 

Please note that Cobra GMRS models with 15 Channels  

may designate different channel numbers for the same frequency.  
For example, a Cobra 15 Channel GMRS model would need to be  
tuned to Channel 11 in order to communicate with a 22 Channel  
GMRS tuned to Channel 15. Please refer to the chart below for  
channel/ frequency number compatibility. 

A =  Channel No. for 22 Channel FRS/GMRS Models

B =  Channel No. for 15 Channel GMRS Models

C = Type of Radio Service

D = Frequency in MHz

E = Power Output

 

E

 

1  

1  

FRS/GMRS  

462.5625 

High 

  2  

FRS/GMRS 

462.5875 

High

  3  

FRS/GMRS  

462.6125 

High  

  4  

4  

FRS/GMRS  

462.6375 

High  

  5  

5  

FRS/GMRS  

462.6625 

High  

  6  

6  

FRS/GMRS  

462.6875 

High   

  7  

7  

FRS/GMRS  

462.7125 

High 

  8    FRS  

467.5625 

Low 

  9    FRS  

467.5875 

Low

  10   

FRS 

467.6125 

Low 

  11   

FRS  

467.6375 

Low

  12   

FRS  

467.6625 

Low

  13   

FRS  

467.6875 

Low 

  14   

FRS  

467.7125 

Low

  15  

11  

GMRS  

462.5500 

High  

  16  

8  

GMRS  

462.5750 

High  

  17  

12  

GMRS  

462.6000 

High 

  18  

9  

GMRS  

462.6250 

High  

  19  

13  

GMRS  

462.6500 

High  

  20  

10  

GMRS  

462.6750 

High 

  21  

14  

GMRS  

462.7000 

High  

  22  

15  

GMRS  

462.7250 

High  

CTW285P_DC_MANL.indd   14-15

4/23/13   3:58 PM

Summary of Contents for CTW285P DC












Reviews: