44
Carburetor Cleaning
Clean the carburetor in a well-ventilated area, and take care that there is no
spark or flame anywhere near the working area; this includes any appliance with
a pilot light. Because of the danger of highly flammable liquids, do not use
gasoline or low flash-point solvent to clean the carburetor.
1. Make sure the fuel is shut off.
2. Remove the carburetor.
3. Drain the fuel in the carburetor.
4. Disassemble the carburetor.
CAUTION:
Do
not
use compressed air on an assembled carburetor. Or the pressure may
deform the float. Do not use a strong carburetor cleaning solution, which could
attack the parts of the carburetor; instead, use a mild high cleaning solution safe
for plastic parts.
5. Immerse all the metal parts in a carburetor cleaning solution.
6. Rinse the parts in water.
7. After the parts are cleaned, dry them with compressed air.
8. Blow out the fuel passages with compressed air.
9. Assemble the carburetor
10. Install the carburetor onto the motorcycle.
Exhaust
The pipe is a crucial element to a two-stroke engine. Any kinks, dents, or
damage done to the pipe will result in a performance loss.
NOTE:
Be sure to take the pipe off, and remove any carbon that may be built up.
Carbon build up is created from exhaust. Exhaust has oils in it, and the oils cling
to the walls of the inside of the pipe. Over a long period of time, the diameter of
the pipe will decrease, due to carbon build up. So it is essential to clear the
residue.
CAUTION:
For optimum performance it is important to repack the silencer. Signs of your
silencer needing to be repacked are:
•
The bike is louder than normal.
•
A loss of power.
Summary of Contents for 2009 ECX80 AC
Page 1: ......
