11
M1: Replacing Transmission Lubricant
Tools needed:
•
530 ml (18 oz)
Cobra Power Shift Transmission Lubricant
•
large flat blade screwdriver
•
13 mm wrench or socket
Procedure:
1.
Begin this procedure with a bike that has been ridden more than 5 minutes
but less than 10 minutes. It is desired to have the engine warm enough so
that the oil ‘runny’ but not so hot that there is risk of being burned by the
engine or the oil.
Hot oil and hot components on the motorcycle may cause burns.
2.
Lean bike against something or set on stand with oil drain hole.
3.
Using the 13 mm wrench, remove the oil drain bolt located on the right side
of the engine (figure 1).
Figure 1
4.
After it has drained, reinstall the drain screw with gasket.
5.
Remove the oil fill plug and pour in 530 ml (18 oz) 85W 90 gear lubricant.
NOTE:
Leaning the bike over onto it’s left hand side will facilitate the oil filling
procedure.
6.
Reapply the oil fill screw, securely, being sure the gasket is in place.
Summary of Contents for 2009 ECX80 AC
Page 1: ......
