Settings
Your Detector
18 English
Set IntelliMute
After the detector is installed in your vehicle and
IntelliMute
is turned On
using Menu mode, advance to the
Set IntelliMute
setup screen where the
activation point can be set.
From the setup screen:
1.
Press the
City
button to advance one screen.
2.
Press and hold the vehicle accelerator at the desired engine RPMs.
3.
Press the
Mute
button to complete the setting process.
The system will store the engine RPM setting and provide a completion
message on the display as well as a tone or voice message.
NOTE
If the unit is unable to sense usable pulses within three seconds or if you do not
set a rev point within 30 seconds of beginning the setup, IntelliMute will indicate
an error. If you do not try again within five seconds, it will automatically turn Off.
The unit will provide corresponding messages for these conditions.
Once an activation point has been set, you can easily change it by going
directly to Set IntelliMute in User Settings Menu and repeating the three-step
setup process.
Auto Mute Mode
When
Auto Mute
is On, it automatically reduces the audio volume of all alerts
after they have sounded for four seconds. The signals will remain muted for
as long as the signal is detected. When Auto Mute is Off, the alerts will sound
at full volume for as long as the signal is detected. The factory setting for
Auto Mute is On.
Voice or Tone Mode
You can set your detector to sound alerts and confirm menu settings with
either a
Voice
or a
Tone
Alert. Voice Alert provides voice messages in addition
to tones. Tone Alert provides tones only. The factory setting is Voice Alert.
