9
Nothing
Comes Close to a Cobra
®
Wrist Strap and Belt Clip
Install/Remove Antenna
•
1.
To install the antenna turn the antenna into the radio
clockwise to tighten. Do not overtighten
2.
To remove the antenna turn the antenna counterclockwise.
This radio transmitter IC: 906A-MRHH350 has been
approved by Industry Canada to operate with the supplied
antenna. Other antennas are strictly prohibited for use with
this device.
Cet émetteur radio IC: 906A-MRHH350 a été approuvé par
Industrie Canada pour fonctionner avec l'antenne fournie.
D'autres antennes sont strictement interdits pour une
utilisation avec cet appareil.
Batteries and Charger
•
The radio is shipped with a sealed lithium-ion (LiON) battery
pack (P/N CM 110-025) that is rechargeable.
WARNING
The charger provided for this radio is only to be used
to charge the battery pack provided. Do not charge
any other type of batteries in the charger as fire,
explosion or battery damage will occur. Avoiding
extreme room temperatures will also help prolong
the life of the battery pack for the radio.
When your rechargeable batteries begin to discharge too
quickly, it is time to install a new battery pack. Your radio
will also operate with five (5) high-quality AA alkaline
batteries, using the optional alkaline battery tray.
Installing the Battery Pack
1.
Position the battery pack over the back of the radio.
2.
Engage the battery pack into the radio by sliding to the top
until battery pack is fully seated against radio housing.
3.
Tighten the screw using the end of the belt clip to secure
the battery pack to the radio. Do not overtighten. Only use
the end of the belt clip to tighten the screw.
Belt Clip
Insert Belt Clip onto Radio
16/9
TW
SCAN
WX
H M L
ESC
MEM
ENT SETUP
CALL
FLOATING MARINE HH350
MEM
SAME
ATIS VOX
LOMEDHI
ROG
VHF
T
R
A
B
GMRS
X
C
I
U
Secure Radio
VHF Marine Radio Protocols
Installation
8
English
Install/Remove Antenna
VHF Marine Radio Protocols
Installation
Antenna
Wrist Strap and Belt Clip
•
Belt Clip
Use the spring-loaded belt clip to carry the radio on your
person.
1.
Slide the belt clip into the guide channel on the back of the
radio until it is locked in place.
2.
To attach the wrist strap, insert it through the hole at the
top of the belt clip, feed it through the looped end and pull
tight to secure to the belt clip.
3.
Press open the belt clip, slide it over the belt and release
the clip.
4.
To remove the belt clip from the radio press the tab on the
belt clip, which unlocks the clip, and slide it out.
Install Battery Pack
LiON Battery Pack
Tighten Screw
Wrist Strap Attachment
MRHH350W_FLT_MANL_ENG_MRHH330_ENG_Body 10/30/13 2:39 PM Page 8
