Field Service Procedure – Replacement Pol Motor Kit, USAT
Page 7 of 7
Document No
136481 Rev A
Copyright © Sea Tel, Inc 2012 - The information contained in this document is proprietary to Sea
Tel, Inc. This document may not be reproduced or distributed in any form without prior written
consent of Sea Tel, Inc.
11. Verify the tension of the belt by pressing on it at the
central position between the motor pulley and the main
drive sprocket. There should be a little give, but the belt
should be tight enough that the axis will drive correctly,
without skipping on the teeth of the pulley. If the belt is too
tight/loose repeat the previous step until the belt tension is
correct and tighten all three of the screws.
12. Install the pol motor bracket to the feed using the
hardware removed in step 3. Apply Loctite 242 to the
thread.
*Note:
Angle the bracket away from the connector to
allow sufficient clearance to connect the
13. Connect the reflector harness D-sub connector to the
motor connection using the hardware removed in step 1.
14. Insert the pol pot connector into the bracket and
connect the reflector harness connection.
15. Secure the pol motor harness to the body of the motor
using a cable tie.
Summary of Contents for Sea Tel
Page 1: ......
