Field Service Procedure – Replacement Pol Motor Kit, USAT
Page 6 of 7
Document No
136481 Rev A
Copyright © Sea Tel, Inc 2012 - The information contained in this document is proprietary to Sea
Tel, Inc. This document may not be reproduced or distributed in any form without prior written
consent of Sea Tel, Inc.
6. Using a pair of 3/16” wrenches remove the standoffs
securing the bracket to the defective pol motors D-sub
connector.
7. Install the pulley on the replacement motor in the same
position as on the defective pot assembly. Apply Loctite
638 to the motor shaft and secure the set screw with
Loctite 222 using a 1/16” Allen wrench.
*Note:
For further information refer to the Loctite
Procedure 121730 provided with this kit.
8. Install the bracket to the replacement motor assembly
using the hardware removed in step 6.
*Note:
The orientation of the connector in relation to the
bracket.
9. Locate the pulley into the belt and install the motor
assembly to the feed using the hardware removed in step
4.n Align the motor with harness exiting downwards, apply
Loctite 242 to the threads, do not fully tighten at this time.
10. Apply downward pressure to the motor to tension the
belt and tighten 2 of the retaining screws.
Summary of Contents for Sea Tel
Page 1: ......
