COBHAM SAILOR 6217, Installation Manual

Page: 418 / 470

Troubleshooting guide SAILOR 6222 VHF DSC
4-4 Chapter 4: Service & maintenance
GPS Position
source used
is different
from the
expected If position input source is set to
Automatic
position (see System Setup) sentences from the
following talkers GP, GL, GN (and GA) are
prioritized.
Position source is selected by the quality
indicator:
1. Differential
2. Precise, Autonomous, Float_RTK, Realtime_RTK
3. Estimated and Manuel
4. Unknown (for instance if not supported in
sentence)
5. Simulated and Invalid
On equal priority the following port order is used:
1. NMEA
2. NMEA HS
3. LWE1
4. LWE2
5. LWE3
6. INM-C
The device will automatically switch to the
position source with the highest priority available
after 5 seconds when switching to a lower
priority input and 30
seconds when switching to
a detected higher priority input.
GPS Potion
source
selected via
LAN is
different
from the
expected The SAILOR 6588 DGNSS Receiver can transmit
position over LAN/LWE. Automatic discovery and
selection of up to three (LWE1, LWE2 and LWE3)
SAILOR 6588 DGNSS Receiver source inputs are
supported via SLP.
If any of the LWE source inputs are manually
programmed in System Setup, this will be
excluded from automatic discovery.
Available source inputs will discover and use the
SAILOR 6588 DGNSS Receiver LWE sources with
the most important role (primary, secondary, …)
Action Symptom Remedy
Table 4-1: Troubleshooting guide