Cobalt_OM_preprint_shell.fm Page 2 Wednesday, March 1, 2006 5:39 AM
6
-
2
46 Owner’s Manual
COBALT
46
Y
ACHT
S
ECTION
6
Break-In
Careful break-in allows internal engine components
to “seat” properly, resulting in maximum engine life
and performance. Refer to the propulsion unit and
generator operator’s manuals for manufacturers’
break-in requirements.
Before Each Use
See Boaters’ Checklist label at helm.
1. Test for proper operation of the carbon
monoxide detector; refer to the carbon
monoxide detector operator’s manual.
2. Check fluid levels of engines, transmissions,
freshwater tank, waste holding tank and trim tab
reservoir.
3. Check the air conditioning and generator
seacocks and hoses for leaks. If you notice a
leak, see your authorized Cobalt dealer.
4. Check the air conditioning and generator
seawater strainers for leaks and accumulation
of debris.
• If a hose is leaking or damaged, close the
appropriate seacock. See your authorized
Cobalt dealer for repairs.
• If debris is seen within the container, close the
appropriate seacock and remove the strainer
cover. Lift strainer from container and
thoroughly clean. If the container is full of
sediment, remove the plug at the bottom of the
container and allow water to drain into the
bilge. Remove the container and clean any
sediment. Install the container and plug. Install
strainer in container and secure cover. Open
the seacock and check for leaks.
5. Start engine and the generator. Check all
exhaust systems for leaks. If you notice a leak,
see your authorized Cobalt dealer.
6. Check all fuel lines and connections at fuel
tanks, engines and the generator for leaks. If
you detect a fuel leak, immediately see your
authorized Cobalt dealer.
7. Check the portable and automatic fire
extinguishers for proper charge.
8. Check the battery charge of both engine
batteries. Be sure that the batteries can start
the engine(s) and the generator before
proceeding on your cruise.
Every 50 Hours
1. Be sure to clean seawater strainers as
described in
Before Each Use
, Step 3.
2. Check propellers for damage. If bends, cracks
or other damage are found, consult your
authorized Cobalt dealer for service. Do not
continue to use badly damaged propellers.
Using damaged propellers may damage the
drive system within time.
Every 100 Hours
1. Clean the bilge area. Make sure all drain
passageways are clear. Refer to
Bilge
, in this
section, for cleaning instructions.
Monthly
1. Test the GFCI outlet circuit breaker feature of
each GFCI outlet. Push the test button on each
outlet. Power should be interrupted to all the
outlets onboard. Press the reset button to
restore power. If power is not interrupted,
consult your authorized Cobalt dealer.
CAUTION
• Seacocks can only be replaced when
the boat is out of the water.
• Make sure a seacock is in the CLOSED
position before replacing a hose.
CAUTION
Seacock must be in the CLOSED
position before servicing a strainer.
A
DANGER
Avoid the risk of fire or explosion. DO
NOT operate your boat if a fuel leak is
detected. All fuels are combustible. A
fuel leak must be repaired before
starting the engine or the generator.
