6 •
Important: Always read and follow operating instructions.
7.
Place tire/wheel assembly on pedestal with the
mounting side up (see figures 8a and 8c) and with the
anti-rotation pin located inside one of the lug holes.
Use the anti-rotation extention pin (figure 8b) for
reverse mount tire/wheel assemblies.
Figure 8a - Place Conventional Tire/Wheel Assembly on
Pedestal with Anti-Rotation Pin in Lug Hole
Figure 8b - Place Anti-Rotation Extension Pin over Anti-
Rotation Pin
Figure 8c - Place Reverse Mount Tire/Wheel Assembly on
Pedestal with Anti-Rotation Extention Pin in Lug Hole
8.
Place the center mount lock shaft through center
of wheel (figure 9). Push it down and turn 90-degrees
clockwise to clamp wheel to pedestal (figure 10). Now
tighten by turning the knobs by hand in a clockwise
direction.
Figure 9 - Place Center Mount Lock through Wheel Center
Figure 10 - Tighten Tire/Wheel Assembly to Pedestal
9.
Move the swing arm into position. Pull the lock-
ing handle forward to release the slide. Push down
on the top of the vertical slide (figure 11) to move the
demount tool into contact with the rim edge. Push
the locking handle back and lock the slide into place.
As the slide is locked, the mount / demount tool will
move upward approximately 1/8-inch from rim edge.
Figure 11 - Position Mount/Demount Tool
Anti-rotation Pin
Anti-rotation Pin
Extenstion
Anti-rotation Pin
Extenstion
