25
WELLNESS IV CONTROL PANEL
INITIAL START-UP
Your spa will enter Priming Mode (PR) when it is energized. Priming
Mode lasts for less than 5 minutes. Press “Warm” or “Cool” to exit. After
Priming Mode, the spa will run in Standard Mode (see Mode section).
The pump responsible for heating and filtration (pump 1 low-speed on
non-circ system, or the circ pump on circ systems) will be referred to
simply as the pump. In multi-button sequences, if the buttons are
pressed too quickly in sequence, they may not register.
TEMP CONTROL
(80°F - 104°F / 26.0°C - 40.0°C)
The last measured water temperature is constantly displayed. To display
the set temperature, press “Warm” or “Cool” once. To change the set
temperature, press a temperature button again before the display stops
flashing. After three seconds, the display will stop flashing and begin to
display the current spa temperature.
PUMP 1
Press “Jets 1” to turn pump 1 on or off, and to shift between low and
high speeds (if equipped). The low-speed will turn off after 4 hours. High-
speed will turn off after 15 minutes. Low-speed may run automatically at
times, during which it cannot be deactivated from the panel, but high-
speed may be operated.
PUMP 2 / BLOWER (IF EQUIPPED)
Press the corresponding button once to turn the device on or off. The
device will turn off after 15 minutes.
LIGHT
Press “Light” to operate the spa light. Turns off after 4 hours. If your hot
tub is equipped with a multicolor lighting package, then pressing the
“Light” button consecutively will toggle the lights through different colors
modes.
OWNER’S MANUAL
2017
MODE
Mode is changed by pressing “Temp,” then either “Warm or Cool”.
Standard Mode
maintains set temperature.
“St”
will be displayed mo-
mentarily when you switch into Standard Mode.
Economy Mode
heats the spa to the set temperature only during filter
cycles. “
Ec”
will display when water temp is not current, and will alternate
with water temp when the pump is running.
Sleep Mode
heats the spa to within 20°F/10°C of the set temperature
only during filter cycles.
“SL”
will display when water temp is not current,
and will alternate with water temp when the pump is running.
PRESET FILTER CYCLES
The first preset filter cycle begins 6 minutes after the spa is energized.
The second preset filter cycle begins 12 hours later. Filter duration is
programmable for 2, 4, 6, or 8 hours or for continuous filtration (indicated
by ). The default filter time is 2 hours for non-circ systems and 4 hours for
circ systems. To program, press “Warm” or “Cool,” then “Jets 1.” Press
“Warm” or “Cool” to adjust. Press “Jets 1” to exit programming.
Low-speed pump 1 and the ozone generator (if installed) run during
filtration.
At the beginning of each filter cycle all other equipment will run briefly to
purge the plumbing.
AUTOMATIC POLLING (IN STANDARD MODE ONLY)
The pump will activate for 1 to 2 minutes to check the temperature:
Every 30 minutes
Whenever any other pump or blower is turned on
Whenever the set temperature is raised
See Next Page for Error Codes
