2
5
LUXURY SERIES CONTROL PANEL
OWNER’S MANUAL
2022
LUXURY SPAS
Priming the Pumps
As soon as the Priming Mode screen appears on the panel, select
the “Jets 1” button once to start Pump 1 in low-speed and then
again to switch to high-speed. Also, select the other pumps, to turn
them on. The pumps should be running in high-speed to facilitate
priming. If the pumps have not primed after 2 minutes, and water is
not flowing from the jets in the spa, do not allow the pumps to
continue to run. Turn off the pumps and repeat the process.
Note:
Turning the power off and back on again will initiate a new
pump priming session. Sometimes momentarily turning the pump
off and on will help it to prime. Do not do this more than 5
times. If the pump(s) will not prime, shut off the power to the
spa and call for service.
Important:
A pump should not be
allowed to run without priming for more than 2 minutes. Under NO
circumstances should a pump be allowed to run without priming
beyond the end of the 4-5 minute priming mode. Doing so may
cause damage to the pump and cause the system to energize
the heater and go into an overheat condition.
Exiting Priming Mode
The system will automatically enter the
normal heating and filtering at the end of the priming mode, which
lasts 4-5 minutes. You can manually exit Priming Mode by pressing
the “Exit” button on the Priming Mode Screen. Note that if you do
not manually exit the priming mode as described above, the priming
mode will be automatically terminated after 4-5 minutes. Be sure
that the pump(s) have been primed by this time. Once the system
has exited Priming Mode, the top-side panel will display the Main
Screen, but the display will not show the temperature yet, as shown
below. This is because the system requires approximately 1 minute
of water flowing through the heater to determine the water
temperature and display it.
Navigation
Navigating the entire menu structure is done by touching the
screen. When a text item is shown in white on the main screen,
it is selectable. The menu selections on the right side of the
screen can be selected. Select one of these to enter a different
screen with additional controls. Most menu screens time out
and revert to the main screen after 30 seconds of no activity.
The only item that can be changed on the left side of the Main
Screen is the Set Temperature. Touch either the set
temperature line or the water temperature to go to the Set
Temperature screen.
Time-of-Day
Be sure to set the Time-of-Day
Setting the time-of-day is important for determining filtration
times and other background features. “Set Time” will appear on
the display if no time-of-day is set in the memory. On the
Settings Screen, select the Time-of-Day line. On the Time-of-
Day screen, simply select the Hour, Minutes, and 12/24 Hour
segments. Use the Up and Down Buttons to make changes.
Note:
This only applies to some systems: If power is interrupted
to the system, Time-of-Day will be maintained for several days.
Jets
The Spa Screen shows all available equipment to control, as
well as other features, like Invert. The display shows icons that
are related to the equipment installed on a particular spa model,
so this screen may change depending on the installation. The
icon buttons are used to select and control individual devices.
Some devices, like pumps, may have more than one ON state,
so the icon will change to reflect the state that the equipment is
in. Below are some examples of 2-speed Pump indicators.
Summary of Contents for LUXURY 2022 Series
Page 2: ...OWNER S MANUAL 2022 2 LUXURY SPAS ...
Page 49: ...WORLD S BEST BUILT SPAS ...
