Coachmen RV Viking, Owner'S Manual

Page: 11 / 32

11
BED PLATFORM SET-UP 806 MODELS
1. Remove the four bed support poles from inside unit and
place near the front and rear of unit.
2. Pull out bed using strap located at the center of each bed
platform.
3. Insert flat end of support poles into unit frame first then
swing upward and install on support plates located on
the underside of bed platform. Slight lifting on bunk end
will be required to complete install. (Repeat steps 1-3 for
remaining bed platform.)
4. Zip tent sides closed at all four zippers located behind lifter
arms.
5. Install inner bed flaps starting from the camper body
and working outward to bottom of bunk platforms using
attached Velcro fastener.
6. Raise bed platform rain flap and wrap inner flap around
bed corners and lower rain flap over inner flaps at corners.
7. Install shock cord by hooking detached end to eyelet
opposite fixed end. Repeat for opposite end.
8. Locate bed tension rafter poles (usually stored under
respective mattresses).
9. Insert tension rafter into bed bow extension (red cap
located on end).
10. Push tension rafter and bed bow upward and outward and
lock inner end of tension rafter into roof bracket when tent
top is taut. Repeat for other bed.
11. Install lifter arm covers by attaching Velcro located on
opposite side lifter arm.
12. For bed platform disassembly reverse steps 1-3 above.

!
WARNING!
CAUTION: NEVER PULL BUNKS OUT OR PUSH
BUNKS IN, UNLESS ROOF IS EXTENDED TO ITS FULL
HEIGHT. THIS IS A MUST!

! WARNING!
CAUTION: NEVER ALLOW BUNKS TO HANG
UNSUPPORTED, AS THIS WILL CAUSE DAMAGE TO
SLIDE ASSEMBLIES.

!
WARNING!
AS THE CANVAS IS PERMANENTLY ATTACHED TO
THE BUNK AT THE END ONLY, DO NOT PLACE SMALL
CHILDREN OR INFANTS IN BUNK AREA WITHOUT
PROVIDING ADEQUATE PROTECTION AROUND OPEN
EDGES.
DOOR INSTALLATION 806 MODELS
1. Close lower door.
2. Release upper door storage straps (4) while supporting
gently in center.
3. Gently swing door downward to vertical position.
4. Position the bottom of the upper door directly over the
lower door and insert the black plastic guide pins into
corresponding channels in the lower door frame. Securely
latch upper to lower door using latch provided.
5. Push outward on top of upper door and secure top plate to
roof sideboard using (2) turn buttons provided.
6. Attach front and rear tent sections to door frame using
Velcro provided.
7. Check door for smooth operation. Adjustments at top or
re-leveling the unit may be necessary.
8. Reverse steps 1-7 to uninstall.
HELPFUL HINTS:
If door will not open and close properly from outside of the unit,
check to see if upper door is square in frame. If not, this may be
adjusted by adding or subtracting tension on bunk bows.
DOOR INSTALLATION STEPPER DOOR
AND V-TREC MODELS
1. Release upper door storage straps (4) while supporting
gently in center.
2. Gently swing door downward to vertical position.
3. Place door bottom against lower door frame into channel
provided.
4. Push outward on top of screen door. When door is in
vertical position, push downward on door making sure door