6
S e t u p a n d T e a r d o w n P r o c e d u r e s
Tempo Go
Setup and Teardown Procedures
The following is a step-by-step process to set up and tear down the Tempo Go Control Unit and tripods. The diagrams show the
use of two tripods (plus the Control Unit), but these procedures can be followed to incorporate the use of more to meet your
needs. Included is a legend to identify the images used throughout these steps.
1. Fully extend the two tripods. (Full extension is when the sliding plastic collar contacts the bolt near the bottom of the
center tube.) Then, place the tripods side by side, aligning the holes in each tripod’s Leg 1. Secure with the provided
pin as shown in Figure 7.
2. Insert the mounting bracket’s two posts into the tops of the tripods. Use two of the provided pins to secure the posts in
place as shown in Figure 8.
Figure 6: Leg 1 of Each Tripod
Leg 1
Leg 1
Figure 7: Pinned Tripod Legs
Figure 8: Mounting Bracket Secured to Tripods
