7
EN
G
LI
S
H
6
6 7
8
R
3
4
5
PRESS
6
6 7
8
R
3
4
5
PRESS
3
2
1
3. Charging
N.B
. The battery is not charged when sold; therefore, it must be charged before it is used
for the first time. The battery should be charged for at least 7 hours the first time it is used.
1. Make sure that the selector (5) is in the middle setting.
2. Plug the charger’s DC plug into the charger connection socket (7) and then connect
the charger to a power point.
3. The indicator lamp (6) comes on when the battery is charging and goes off when the
battery is fully charged.
4. Normal charging takes 5 hours. When the battery is charged: First disconnect the
charger from the power point and then remove the DC plug from the screwdriver
charger connection socket.
5. For the best possible performance: Do not let the battery remain fully discharged
for a long time.
6. A fully charged Li-Ion battery will keep its charge for up to six months if it is not used.
• Do not use the screwdriver when it is connected to the charger.
• Only use the charger supplied.
• Do not leave the charger connected to the power point after the screwdriver has
been charged.
• Do not charge the battery if the ambient temperature is below 5 ºC or over 40 ºC.
• The battery does not need to be completely discharged before charging.
• The charger is for indoor use only.
4. Use
1. The screwdriver bits are stored in the selector
ring (3), twist the ring until a suitable bit
appears next to the “1” mark on the ring.
2. Push the screwdriver storage lock (2) upwards,
remove the chosen screwdriver bit and insert
it into the screwdriver bit holder (1).Push the
lock (2) back down again to prevent other
screwdriver bits from falling out.
3. Set the desired torque (1 is the lowest
and 9 is the highest) or drill setting.
Summary of Contents for TSL-06A
Page 2: ...2...
