13
EN
G
LI
S
H
19
1
1
3
8
7
2
1
Cutting
Cutting with the blade at an angle of 0°
When cutting workpieces up to 120 mm wide, the sliding feature of the saw is not
needed and the saw can be locked in its back setting with the locking wheel (14).
When cutting workpieces wider than 120 mm, check that the locking wheel (14)
is loosened and that the saw head (4) is moveable before beginning to cut.
1. Release the saw head (4) to its upper setting by removing the stop (16).
2. Move the saw head (4) backwards with the handle (2) and fix it in this position
if needed (depending on the width of the workpiece being cut.)
3. Place the workpiece being cut against the fence (7) on the mitre plate (8).
4. Fasten it with the clamp (19) to the bottom plate to prevent the workpiece from
giving way during the cutting.
5. Press the power switch (3) to start the motor, press the release lever and calmly
and evenly bring down the handle (2) and let the saw blade cut the workpiece.
6. After finishing cutting: Release the power switch (3) and when the motor has
stopped, the saw head (4) can be brought to its upper position.
Caution:
The balance springs of the machine will automatically press the saw
head upwards after cutting. Thus, do not release the handle (2) after finishing cut-
ting, hold the handle and brake carefully when the saw head springs upwards.
