User Manual
CNC Wireless Keypad
CNC-STEP e.K. ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 5
Support: +49 (0)2831/91021-50
12.11.2013
2
Activation and Installation
2 .1
Ac t iva ti ng th e ke y pad
Pick up the remote control and turn it over, so you can see the cover of the battery
compartment.
Loosen the cover by removing both cross-head screws using a Phillips screwdriver.
Remove battery-contact breaker by holding it carefully on the arrow symbol with thumb and
index finger, then pull slowly. Pulling to fast could unintentional throw off the battery.
Now close the battery compartment by using the screws.
Your remote-control is now activated and has to be connected with your PC via dongle.
2 .2
I ns tal lat io n of th e do ngl e
Place your dongle in a free USB-port on your computer where you have installed your CNC
software.
The dongle should now automatically install within seconds including all needed drivers.
Should your computer fail to do so, please install the driver manually in the device manager.
After the installation process has been successfully completed, you keypad is ready for use.
2 .3
Co mp a ti bil ity of t h e o p era ti ng s ys t e m
The keypad is Windows XP, Windows Vista, Windows 7 und Windows 8 compatible!
2 .4
I mp o rt an t !! !
Make sure that the connection between keypad and PC is never lost while pressing keys.
Never unplug the dongle at the same time while pressing a key on the keypad. It is possible,
that the function, you have pressed in this moment,
repeats endlessly until the connection is
reestablished, or you stop it manually via mouse in the software!!!
