E-6
E-5
OPERATION OF RADIO
- PRESS THE KEY ONCE TO SWITCH ON THE SYSTEM POWER.
- PRESS THE
REPEATEDLY TO SELECT THE RADIO MODE AND
THE DESIRED RADIO BAND : FM OR AM (MW).
- FOR AM (MW) STATIONS, ROTATE OR REPOSITION THE SET TO IMPROVE RADIO
RECEPTION.
- FOR FM STATIONS, EXTEND AND ADJUST THE TELESCOPIC ANTENNA TO OBTAIN
THE BEST RECEPTION.
- USE THE FM-MODE BUTTON TO SELECT THE FM-MONO OR FM-STEREO MODE.
IN SOMECASES, WHERE RECEPTION IS POOR, IT MAY BE ADVISABLE TO SELECT
“MONO” MODE, TO IMPROVE CLARITY OF THE RADIO SIGNAL. USE THE FM-MODE
KEY (26) TO SELECT "MONO" OR "STEREO".
KEY
ON/OFF
BAND
MANUAL FREQUENCY ADJUSTMENT (SCAN MODE)
- PRESS (AND IMMEDIATELY RELEASE) THE KEY OR KEY
TO “SCAN” (MANUALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
BY 1-STEP AT A TIME.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY AT EACH
STEP’S POSITION.
- WHEN A DESIRED FREQUENCY OR STATION IS REACHED. IT CAN BE SAVED
INTO ONE OF THE “MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).
NEXT
BACK
AUTOMATIC FREQUENCY ADJUSTMENT (SEEK MODE)
- PRESS AND HOLD (FOR 2 SECONDS) THE OR KEYS
TO “SEEK” (AUTOMATICALLY ADJUST) THE RADIO FREQUENCY “UP” OR “DOWN”
TO THE NEXT AVAILABLE RADIO STATION.
- THE RADIO DIGITAL DISPLAY WILL INDICATE THE EXACT FREQUENCY OF THE
NEXT STATION THAT IS FOUND.
- WHEN A DESIRED STATION IS REACHED. IT CAN BE SAVED INTO ONE OF THE
“MEMORY” POSITIONS. (SEE “RADIO MEMORY” SECTION).
NEXT
RADIO MEMORY (STATION PRESET MEMORY STORAGE)
- AT ANY TIME, THE CURRENTLY DISPLAYED STATION OR FREQUENCY CAN BE
STORED INTO ONE OF THE MEMORY POSITION.
- TO STORE A DESIRED STATION INTO A SPECIFIC MEMORY POSITION, FIRST TUNE
IN THE DESIRED STATION AS USUAL.
- PRESS KEY (18) ONCE.
- PRESS OR TO SELECT DESIRED MEMORY POSITION.
(THERE ARE 30 MEMORY POSITIONS FOR "FM" AND 20 MEMORY POSITIONS FOR
MW (AM).
- PRESS KEY (18) ONCE TO SAVE THE SELECTED STATION INTO THE
SELECTED MEMORY POSITION.
- TO RECALL ANY SAVED MEMORY, SIMPLY PRESS OR ,
THE SAVED RADIO-STATION WILL BE RECALLED.
- TO CLEAR THE MEMORY OF ANY POSITION, SIMPLY SAVE A NEW STATION TO
THE SAME MEMORY POSITION.
PROG
MEM +
MEM -
PROG
BACK
MEM +
MEM -
- WHEN OPENING THE CD-DOOR, ALWAYS ENSURE THE DISC IS NOT IN MOTION (NOT
SPINNING) WHEN YOU OPEN THE CD-DOOR. ALWAYS PRESS "STOP" BUTTON TO
STOP THE DISC SPINNING FIRST.
- PLACE A CD INTO THE COMPARTMENT WITH THE LABEL-SIDE (PRINTED SIDE OF
DISC) FACING UPWARDS. PRESS DOWN IN THE CENTER PART OF DISC UNTIL THE
DISC "LOCKS" ONTO THE CENTER SPINDLE.
- WHEN THE CD HAS BEEN PLACED ONTO THE CENTER SPINDLE, GENTLY LOWER
THE CD-DOOR DOWNWARDS UNTIL IT LOCKS SHUT.
- THE CD IS NOW READY TO BE PLAYED.
- TO REMOVE A DISC, FOLLOW THE SAME PROCEDURE AS DESCRIBED ABOVE,
EXCEPT TO REMOVE THE CD INSTEAD OF INSERTING IT INTO THE COMPARTMENT,
BY PLACING ONE FINGER AT THE MIDDLE OF DISC (CENTER SPINDLE) & THE OTHER
AT THE EDGE OF THE DISC & GENTLY PULLING UPWARDS.
- IMPORTANT : ALWAYS HOLD A CD BY ITS EDGES. AVOID GETTING ANY FINGER
PRINTS, SMUDGES OR DIRT ONTO THE SURFACE OF A DISC. IN CASE THIS
HAPPENS, USE A SPECIAL CD-CLEANING CLOTH OR CLEANING KIT TO REMOVE THE
DIRT OR SMUDGES.
PLEASE MAKE SURE TO ALWAYS FOLD DOWN THE HANDLE ALL THE WAY BEFORE
OPENING THE CD DOOR.
IMPORTANT:
INSERTION & REMOVAL OF DISCS
SIDE VIEW:
1
SIDE VIEW:
2
