All content © 2015, cmotion GmbH. All specifications subject to change without notice. http://www.cmotion.eu
17/29
Run Simulation
Run Simulation (displayed as “Run Simul”) provides a visual feedback on the
hand unit
to
confirm the ‘Record’ button has been pressed when triggering cameras that do not provide a
real-time run/stop feedback.This feature is used for cameras that do not offer record feedback
■
To activate Run Simul, ensure the camera in NOT recording. Select Run Simul and
turn ON. When you press the “Record” button once, please check the camera is
recording. Press again to stop recording.
Note
: If the camera stops recording while “Run Simul” is being displayed,
turn Run Simul OFF, ensure the camera is not recording and re-activate
“Run Simul”
CoC (Circle of Confusion)
To set the appropriate CoC for accurate Depth of Field calculations, use the numeric entry
process as explained in section 4.4 on page 15.
Note
: CoC can be created and displayed in either metric or imperial units.
This can be changed through LENS > SYSTEM UNIT.
Note
: CoC will only be displayed if the optional ‘Lens Data License Key’ is
installed and a lens file is active.
4.5.2. Control Units
This sub menu allows you to assign the knob, pressure sensitive joystick and rocker switch to
control motors assigned to Focus, Iris and Zoom. First, select the controller, then select the
required scale.
Note
: When changing the function of a control unit, the original scale will
automatically swap to the control unit assigned with the newly selected
scale.
Note
: It is also possible to turn each control unit OFF.
4.5.3. Motors
In the motors menu, each
cforce
/
cforce
mini
motor is identified by it’s serial number. By select-
ing individual motors, you can change the following settings; scale, direction, torque, ramp and
speed limiter. Each setting is stored within the individual memory of each motor.
Note
: The menu shows the motor name (only
cforce
and
cforce
mini
motors can be used at the time of writing) and the serial number of the
motor in blue.
Scale
Select the desired scale from the menu by pressing the corresponding side button. You can
assign a motor to Focus, Iris or Zoom.
Direction
To change motor direction select the Direction side button. Select left or right by pressing the