AN113
Rev 1.0 | Page 9/34
www.hoperf.com
Table 5. Push Buttons Functions Definition of Pulse Scheme
Push Button
Function Description
K1, K2,K3, K4, K5
Turn on the LED(s) on the CMT2250A-EM for 2 seconds in the manner shown in Table 6, and then
the LED(s) will be switched off automatically.
K6
Not used in this scheme
The user can follow below instructions to experience the Pulse scheme.
1.
Install the latest RFPDK on the PC (refer to “Section 7.1 Installation Steps”) and connect the USB programmer to the PC
with a USB cable, then start the RFPDK on the PC.
2.
Connect the CMT2150A-EM to the USB Programmer with EM-Connector, select CMT2150A on the RFPDK, stay in Basic
Mode, select the Pulse configuration on the configuration list, as shown in figure below, and burn the configuration to the
CMT2150A-EM.
Figure 8. Selecting the Pulse Configuration of CMT2150A
3.
Repeat step 2 to burn the Pulse configuration to the CMT2250A-EM on the RFPDK
Figure 9. Selecting the Pulse Configuration of CMT2250A
4.
After the programming is done, the user can start to use the evaluation modules in Pulse scheme.
In this scheme, push button K1-K5 are used to control the LED1-4 with the mapping rule shown in the table below, K6 is
unused in this scheme.
