AN113
Rev 1.0 | Page 11/34
www.hoperf.com
Figure 10. EMs Used to Experience Periodic Tx Scheme
Table 7. Push Buttons Functions Definition of Periodic Tx Scheme
Push Button
Function Description
K1, K2
Manually turn the LED1-LED3 on for 500 ms and turn them back to off.
K3
Manually turn the LED1-LED3 on for 500 ms and turn them back to off. Press K3 more than for 5 seconds
will send out the study packet.
K4, K5, K6
Not used in this scheme
The user can follow the below instruction to experience the modules in Periodic Tx scheme.
1.
Install the latest RFPDK on the PC (refer to “Section 7.1 Installation Steps”) and connect the USB programmer to the PC
with a USB cable, then start the RFPDK on the PC.
2.
Connect the CMT2150A-EM to the USB Programmer with EM-Connector, select CMT2150A on the RFPDK, select the
Advanced Mode, select the Periodic configuration on the configuration list, as shown in figure below, and burn the
configuration to the CMT2150A-EM.
Figure 11. Selecting the Periodic Tx Configuration of CMT2150A
3.
Repeat step 2 to burn the Periodic Tx configuration to the CMT2250A-EM on the RFPDK
Figure 12. Selecting the Periodic Tx Configuration of CMT2250A
4.
After the programming is done, the user can start to use the evaluation modules in Periodic Tx scheme.
