6. Assembly and starting
39
GB
466790
V_02/06/2010
• Make sure the intake air is dry and dust-free.
• Do not set up the compressor in damp or wet rooms.
• The compressor may only be used in suitable rooms (with good ventilation and an ambient tem-
perature from +5 °C to +40 °C). There must be no dust, acids, vapors, explosive gases or inflam-
mable gases in the room.
• The compressor is designed to be used in dry rooms. It is prohibited to use the compressor in
areas where work is conducted with sprayed water.
• The oil level in the compressor pump has to be checked before putting the equipment into oper-
ation.
6. Assembly and starting
6.1. Fitting the wheels (3)
Fit the supplied wheels as shown in Fig. 5.
6.2. Fitting the supporting foot (4)
Fit the supplied rubber stopper as shown in Fig. 6.
6.3. Fitting the air filter (1)
Remove the transportation stop with a screwdriver or similar and screw the air filter (1) securely to
the equipment. (Fig. 7)
6.4. Replacing the oil sealing plug (14)
Remove the transportation cover from the oil filler opening with a screwdriver and insert the sup-
plied oil dipstick (14) into the oil filler opening. (Fig. 8)
6.5. Voltage
The compressor is equipped with a mains cable with shock-proof plug. This can be connected to
any 230 V ~ / 50 Hz shock-proof socket which is protected by a 16 A fuse. Before you use the
machine, make sure that the mains voltage complies with the specifications on the rating plate.
Long supply cables, extensions, cable reels etc. cause a drop in voltage and can impede motor
start-up. In the case of low temperatures below +5 °C, motor start-up is jeopardized as a result of
stiffness.
6.6. On/Off switch (8)
To switch on the compressor, pull out the red knob (8).
To switch off the compressor, press the red knob (8) in again. (Fig. 2)
6.7. Adjusting the pressure: (Fig. 1)
• You can adjust the pressure on the pressure gauge (6) using the pressure regulator (7).
• The set pressure can be taken from the quick- lock coupling (5).
• The tank pressure can be read off using the manometer(12).
• The tank pressure can released via the quick coupling (16).
Attention!
Important!
You must fully assemble the appliance before using it for the first time.
466790.book Seite 39 Freitag, 25. Juni 2010 9:58 09
