CMi 462442, Original Operating Instructions, Page: 39 / 118

GB
39
– Check the electrode distance.
Correct distance: 0,7–0,8 mm
Cleaning the spark plug
– Remove rust from the electrode with a wire
brush with brass bristles.
Inserting the spark plug
– Insert a cleaned or new spark plug and tighten
by hand.
– Tighten the hand-tightened spark plug using the
spark plug wrench by approximately another
quarter turn; tightening any more will damage
the threads.
– Replace the ignition cable connector firmly on
the spark plug.
Storage and transport
Storage
– Let the product cool before storing.
– Store the product in a dry, well-ventilated place.
Longer downtimes (3 months or longer)
Always remove fuel from the product before storing
for longer periods.
– Empty the tank.
– Start the motor and let it run until the motor swit-
ches off by itself.
Transportation in a vehicle
– Allow the product to cool down.
– Empty the tank.
– Secure the product to stop it slipping and tipping
over.
Disposal
Disposing of the product
Do not dispose of the product with the household
waste! Proper disposal is mandatory. Information
can be obtained from the responsible waste disposal
facility.
Disposing of packaging
The packaging consists of cardboard and appropri-
ately marked films, which can be recycled.
– Take these materials to a recycling facility.
Troubleshooting
If something doesn't work…
Malfunctions are often caused by minor faults. You
can easily remedy most of these yourself. Check
against the following table first before contacting
OBI Service. You will save yourself a lot of trouble
and possibly money too.
Product damage! To clean the spark
plug, use only wire brushes with brass
bristles. Bristles of any other material
will damage the electrode!
Product damage! Tighten the spark
plug only when motor is cold.
Environmental damage, fire hazard!
Avoid damage caused by leaking fuel:
Empty the tank before disposal.
Risk of injury! Improper repairs can
result in the product functioning unsa-
fely. This endangers yourself and your
environment.
Fault/malfunction Cause Remedy
Motor does not start. Tank empty? Filling with fuel – Page 36
Ignition switch on O? Set the ignition switch to position
I.
Ignition cable connector loose? Push the connector firmly onto
the spark plug.
Ignition cable connector
contaminated? Clean connector.
462442_Spruehnebler_Benzin.book Seite 39 Montag, 21. Dezember 2015 5:24 17