9
DISPLAY CODE IN USE
If you set up the remote control using the
MANUAL SEARCH
procedure, obtain and make a note of the code in use as follows:
1.
Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter the
code for.
2.
Release the button. The indicator light will
fl
ash. Press
the
TV / radio
button for an instant.
3.
After a pause of several seconds, the indicator light pro-
duces four sets of
fl
ashes, spaced out, corresponding to
the code to be obtained. Count the number of
fl
ashes.
Each set of
fl
ashes corresponds to one
fi
gure in the
code. Ten
fl
ashes correspond to the
fi
gure 0.
4.
Make a note of the code obtained on the label on the in-
side of the battery cover. You may need it in future.
Code obtained =
1306
6 SEC.
or
ENTERING THE CODE DIRECTLY
(only to be performed if you know the speci
fi
c code to be set)
If they do not appear, repeat the procedure. If the result is still negative, it means the code indicated
is not included in the remote control.
1.
Press and hold down for 6 seconds the device selection
button corresponding to the device you wish to enter the
code for.
2.
Release the button. The indicator light
fl
ashes
.
Immediately enter the speci
fi
c code previously found.
(e.g. 1306).
3.
Three long
fl
ashes indicate a correct setting.
6 SEC.
or
NOTE:
During the search the indicator stops
fl
ashing and the remote control exits the programming mode in the
following cases:
• if for 12 seconds the button indicated is not pressed or if another button is pressed
• if the list of codes to
fi
nd is terminated. In this case, visit the
www.cme.it
website.
