FIG. 10 FIG. 11
Remove the lamp lens by unscrewing it slightly counter clockwise. Now take the
red and black wires at the other end of the wire cable that is through the pedestal
and run them through the hole in the center of the bottom of the lamp. You will
find two screws that are marked
+
and
-
. Connect the black wire to the
–
screw
and the red wire to the
+
screw as shown in Fig. 10. Mount the lamp to the
pedestal adapter with the three 6-32 X ¾” Phillips pan head tapping screws
provided with the light. Make sure that you use the three insulator washers to
prevent a short (see Fig. 11). Attach the lamp cover to the light as shown in Fig.
12.
FIG. 12 FIG. 13
Next, loosen the twelve 3/8”-16 x 1” socket head cap screws on the header so
that you can insert the upper tubes of the port and starboard front and rear tube
assemblies as shown in Fig. 13.
Insert all 4 of the upper tubes.
7
Summary of Contents for Typhoon Tower
Page 1: ...OWNER S MANUAL 1...
