Page 2
Installation Instructions
PARTS INCLUDED FOR INSTALLATION:
4 or 6 Rare Earth Heat Resistant Magnets (
Most DV ReFace Enclosures use 4 magnets. Larger sizes use 6 magnets.)
Figure 1
Figure 2
PLEASE NOTE:
Your
CMC
ReFace Screen must be installed and adjusted correctly. Please
read and follow the installation instructions carefully. If you do not feel confident
that you are equipped to complete the installation properly please contact
Fireplace Doors Online
.
If you have questions:
Please contact
Fireplace Doors Online
before proceed-
ing with installation.
Figure 3
INSTALLATION:
Carefully unpack the DV ReFace Screen.
Remove protective plastic film from polished metal overlay or trim if so equipped.
Remove operating screens or screen doors from the DV ReFace Screen, if so
equipped, to prevent damage to the screens and to the DV ReFace finish.
○
Set the screens aside in a safe place.
NOTE:
Not all DV ReFace Screens have removable screens. Do not try to remove
fixed screens.
Remove the louvers from the DV ReFace Screen, if so equipped, by gently pushing
on the louvers from the back of the frame. Use care not to drop the louvers.
○
Set the louvers aside in a safe place.
Align the DV ReFace Screen with the bottom of the DV-Gas Fireplace. Note where
the DV ReFace frame lines up with the DV-Fireplace frame.
(Figure 1)
Align the Rare Earth Magnets on the back of DV ReFace Screen frame. Place the
magnets where they will fully contact the DV-Fireplace frame.
(Figure 2)
Handle the magnets carefully!
They are very strong and can easily pinch fingers.
NOTE:
The Magnets must make full contact with the metal DV-Fireplace frame and
the DV ReFace Screen must lay perfectly flat against the fireplace frame.
NOTE:
The DV-Fireplace frame must be clean and free from dirt, oil, plaster, grout,
or any other contaminant. The DV ReFace Screen could come loose from the fire-
place if the mounting surface is not properly and thoroughly cleaned.
Carefully install the DV ReFace Screen on the DV-Fireplace. (
Figure 3)
CAUTION
: Keep fingers from between DV ReFace and the DV-Fireplace.
Check that the DV ReFace Screen is aligned flat, plumb, and square.
Replace the louver (s) in the DV ReFace Screen if so equipped.
Replace the screen or screen doors in the DV ReFace if so equipped.
NOTE:
Failure to align the DV ReFace Screen properly may result in damage di-
rectly attributable to improper installation.
