Operation
MODEL CMA-181VL INSTALLATION & OPERATION MANUAL Rev. 1.00
Page
10
3. Operation
3.1.
Initial Setup
3.1.1. Rinse and Wash Temperatures
1. Turn the Power switch to the "ON" position.
2. After the unit has warmed up, note the wash and rinse temperatures. The
wash temperature must be 150°F minimum. The rinse temperature must be
180°F minimum
3
. If necessary, adjust the temperatures by removing the
front kick panel and turning the thermostat adjustment clockwise to increase,
counterclockwise to decrease. This adjustment controls the wash and rinse
temperatures.
3.1.2. Post Instructions
1. Install wall chart and instruct the operator on proper cleaning and operation
of the CMA-181VL.
3.2.
Startup Procedures
1. Open the door of the unit and check that the scrap screen is in place, and that the
spray arms and end plugs are secure.
2. Close the door and turn the Power switch to the "ON" position.
The glass washer will be automatically filled with water to the correct level.
3. Once the water is filled
to the proper level, press the rocker switch marked “START”
– the unit will automatically begin its cycle.
4. Check operating temperatures
— Adjust if necessary. See section 3.1.1 Rinse and
Wash Temperatures.
5. At the end of the wash period, drain the glass washer by pushing the rocker switch
marked “DRAIN”. Clean the wash tank screen and scrap tray screen. Remove and
clean the spray arms. (See wall chart instructions).
3
Rinse cycle temperature must be observed during a rinse cycle while the unit is in operation.
.
