Club Car TURF 2 XRT, Owner'S Manual

Page: 38 / 44

Rear Fender Installation
36 2001 Turf 2 XRT Gasoline Vehicle Owner’s Manual
4. Make sure fender is correctly aligned in the vehicle.
4.1. Make sure outer fender rib is flush with the inside surface of the upper side panel (Figure 23,
Page 36).
4.2. Move fender as far forward as possible. There should be no gap between the fender and side
panel (Figure 23, Page 36).
5. Drill three 5/16 inch holes through the fender using existing frame holes as guides (Figure 23,
Page 36).
6. Install bolt (1), large flat washers (2), and locknut (3) at top hole as shown (Figure 23, Page 36).
Tighten mounting hardware at both upper holes to 4.0 N·m (35 in-lb).
7. Install bolt (1), large flat washer (2), small flat washer (4) and locknut (3) in both forward-facing holes in
frame and fender (Figure 23, Page 36). Tighten to 4.0 N·m (35 in-lb).
8. Repeat steps 3 – 7 for the other rear fender.
9. Lower cargo bed.
Figure 23 Drill Additional Mounting Holes
2
2
3
2
1
3
4
1
Before drilling holes,
move fender as far
forward as possible.
Do not allow any gap
between fender and
side panel.
FENDER RIB
UPPER
SIDE PANEL