Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 387 / 414

GASOLINE VEHICLE - TRANSAXLE Transaxle Removal
24
20. Roll powertrain out from under vehicle.
21. Place blocks under the engine pan so they will completely support the engine and keep it level to the floor
(Figure 24-12, Page 24-11) . See following NOTE.
NOTE: Place the blocks so they will support the engine when the transaxle is detached and moved away from the
powertrain.
3126
Figure 24-12 Remove Powertrain and Place Wood Blocks Under Engine Pan
22. Remove oil drain plug and drain all oil from transaxle. Dispose of gear oil properly.
23. Remove driven clutch. See Driven Clutch Removal, Section 23, Page 23-14.
24. Remove eight bolts (1) total that secure transaxle to powertrain (Figure 24-13, Page 24-12) at the following
locations:
– Four bolts (1) at engine pan (2).
– Two bolts (1) at clutch plate (3).
– Two bolts (1) at muffler bracket.
25. Roll transaxle from engine pan (2). See following NOTE.
NOTE: The transaxle weighs approximately 58 lb (26.2 kg).
26. If replacing transaxle, remove leaf springs, wheels, hubs and brake assemblies and retain for installation on new
transaxle.
See Rear Suspension section. See Wheel Brake Assemblies section.
2019 Precedent Villager 2 Maintenance and Service Manual Page 24-11