Club Car Precedent Villager 2, Maintenance And Service Manual

Page: 372 / 414

23
Driven Clutch GASOLINE VEHICLE - CLUTCHES
DRIVEN CLUTCH REMOVAL
1. Remove the drive belt as instructed. See Drive Belt Removal on page 23-3.
2. Remove the bolt (1) and mounting washer (2) from the transaxle input shaft (Figure 23-14, Page 23-13) .
3. Grasp the driven clutch assembly and slide it off the shaft.
4. Leave the key (12) in the keyway.
DRIVEN CLUTCH DISASSEMBLY
CAUTION
• The driven clutch is balanced as an assembly. Before disassembly, make match marks on the driven
clutch fixed sheave and moveable sheave so they can be reassembled in the same positions.
1. Make match marks on the driven clutch fixed sheave and on the moveable sheave to maintain balance upon
reassembly.
2. Using external snap ring pliers, remove the retaining ring (4) (Figure 23-15, Page 23-15) . See following
WARNING.
WARNING
• Do not place fingers under the cam when removing the cam. The moveable face may spin when the
cam buttons release from the cam ramps, resulting in severe personal injury.
3. Insert a puller plug (2) (Figure 23-16, Page 23-15) into the shaft bore and use a driven clutch cam puller (1) to
remove the cam (3) from the fixed sheave.
4. Remove the spring (6) (Figure 23-14, Page 23-13) .
5. Retain the key (4).
6. Slide the moveable sheave (9) off the fixed sheave (11).
Page 23-14 2019 Precedent Villager 2 Maintenance and Service Manual