UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Unitized Transaxle Removal
Page 16-14 2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual
16
Unitized Transaxle Removal, Continued:
14. Remove the drive belt.
14.1. Grasp belt midway between drive and driven clutch and pull up on belt to force the driven clutch
sheaves apart. Roll the belt counterclockwise while pulling it off driven clutch (Figure 16-33, Page
16-14).
15. Remove the driven clutch retaining bolt and remove the driven clutch from the unitized transaxle (Fig-
16. Loosen, but do not remove, the governor arm retaining bolt. Remove the governor arm from the shaft
17. Remove screws securing the governor cable bracket to transaxle (Figure 16-36, Page 16-15).
18. Remove screws securing the accelerator cable bracket to transaxle (Figure 16-37, Page 16-15).
NOTE: The governor cable and the accelerator cable should remain attached to the governor arm.
19. Remove the two bolts that secure the differential lock cable bracket to the transaxle housing and
unhook the cable spring from the differential lock arm (Figure 16-38, Page 16-15).
Figure 16-32 Position Powertrain
Figure 16-33 Remove Drive Belt
Figure 16-34 Driven Clutch
Figure 16-35 Governor Arm
APPROX.
ENGINE
PAN
9 in. (22.9 cm)
DRIVE CLUTCH
DRIVEN
CLUTCH
RETAINING BOLT
Leave cable
connected.
Leave cable
connected.
GOVERNOR ARM
RETAINING BOLT
