UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
Unitized Transaxle Removal
2001 Pioneer 1200 Gasoline Vehicle Maintenance and Service Manual Page 16-9
16
3.5. Remove the differential lock cable.
3.5.1. Place differential lock handle in the disengaged direction.
3.5.2. Using a pair of pliers, apply pressure to the locking tabs of the cable end (1) where it
attaches to the differential lock handle mounting bracket (Figure 16-13, Page 16-8).
3.5.3. While maintaining pressure on the locking tabs, pull the differential lock cable toward the
rear of the vehicle to disconnect the cable from the bracket (Figure 16-13, Page 16-8).
3.5.4. With handle in the engaged position and the cable disconnected from the bracket, rotate the
cable connector toward the driver side of the vehicle to disconnect the cable from the differ-
ential lock lever (1) (Figure 16-14, Page 16-9).
3.5.5. Remove wire tie (6) securing the cable to the vertical support (Figure 16-117, Page 16-50).
3.6. Remove the cover from the electrical component box. Then loosen the hardware securing the
accelerator cable to the box. Disconnect the cable from the actuator cam and remove it from the
box (Figure 16-16, Page 16-9).
3.7. Disconnect the engine ground wire from the oil filler tube mounting bracket (Figure 16-17, Page
Figure 16-14 Differential Lock Cable Removal
Figure 16-15 Fuel Line
Figure 16-16 Accelerator Cable
CCI 1020
46601
REDUCED STEERING
CONTR
OL MA
Y CAUSE
SERIOUS INJUR
Y OR DEA
TH
Disenga
ge diff
erential loc
k on
paved surfaces.
WARNIN
G
1
2
Rotate the cable
connector toward the
driver side of the vehicle
to disconnect the cable
from the differential lock lever.
Club Car
Remove fuel line.
TOP VIEW
Loosen retaining nuts to remove
accelerator cable from electric box.
