Club Car DS Villager 4, Maintenance And Service Manual

Page: 398 / 510

19
Key Switch
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
7. Connect the blue and yellow wires to the headlight switch terminals.
8. Install the instrument panel.
9. Connect the battery and spark plug wire.
KEY SWITCH
See General Warnings on page 1-2.
Figure 19-36 Key Switch
KEY SWITCH REMOVAL
1. Disconnect the battery and spark plug wire.
2. Remove the instrument panel.
3. Disconnect the wires from the key switch (1) (Figure 19-36, Page 19-32) .
4. From the back of the instrument panel, push down on the retaining tabs and remove the key switch cap (2).
5. Hold the key switch and remove the switch retaining nut (3) from the outside of the instrument panel.
6. Remove the washer (4) and the key switch
KEY SWITCH INSTALLATION
1. Install the key switch (1) and washer (4) into the instrument panel (Figure 19-36, Page 19-32) .
2. Install the key switch nut (3). Tighten the nut to 35 to 45 lb·in (4 to 5 N·m).
3. Install the key switch cap (2).
4. Connect the wires to the key switch terminals. See the following table.
_
Terminal Wire Color
1 Blue
TABLE CONTINUED ON NEXT PAGE
Page 19-32 2020 Precedent,Villager 2 and 4 Maintenance and Service Manual