19
Solenoid
GASOLINE VEHICLE - ELECTRICAL
COMPONENTS
7.1.
Tighten nut on belt tension tool 1/2 turn and check belt tension with gauge
.
NOTE:
To prevent errors in measurement caused by residual tension, ensure to loosen, then reapply, the Universal
Belt Tension gauge between measurements.
7.2.
Continue to tighten in 1/2 turn increments until proper belt tension is achieved.
– Proper tension for a
used
starter/generator belt is 75 to 85 lbf (334 to 378 N).
– Proper tension for a
new
starter/generator belt is 120 to 130 lbf (534 to 578 N).
8.
Seat the belt.
8.1.
Remove all other tools.
8.2.
The belt tension tool can be temporarily left in place.
8.3.
Connect battery only. DO NOT CONNECT SPARK PLUG WIRE.
See Connect the Battery - Gasoline
Vehicles on page 1-4. See following WARNING.
WARNING
• Remove pry bar before starting engine.
• Ensure clearance between F2 terminal and starter/generator bracket before starting engine.
8.4.
Engage starter and crank engine a minimum of 5 seconds and a maximum of 15 seconds to fully seat
the belt into pulleys and help eliminate any slack.
9.
Repeat step 7.
10.
Maintain tension and tighten adjustment nut (4) to 15 to 18 lb·ft (20 to 24.5 N·m). Tighten hex nuts (7) to 20 to
25 lb·ft (27 to 34 N·m)
.
11.
Remove belt tension tool.
12.
Confirm proper belt tension with a final measurement.
13.
Connect spark plug wire.
SOLENOID
See General Warnings on page 1-2.
SOLENOID REMOVAL
1.
Disconnect the battery and spark plug wire.
2.
Remove the nuts (1) from each post
.
Page 19-18
2020 Precedent,Villager 2 and 4 Maintenance and Service Manual
Summary of Contents for DS Villager 4
