Club Car DS Villager 4, Maintenance And Service Manual

Page: 356 / 510

18
Test Procedures
GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM
TEST PROCEDURE 14 – Multi-Purpose Buzzer and Multi-Purpose Buzzer Limit Switch
NOTE: Multi-purpose Buzzer: This is a voltage test.
A multi-purpose buzzer is mounted on the back side of the instrument panel. On some models, another multi-purpose
buzzer is also mounted on a bracket at the left rear of the vehicle. The multi-purpose buzzer is powered by the
10-amp ATM fuse.
1. If necessary, see Testing Basics.
2. Remove the instrument panel.
3. Check for proper wiring and tight connections.
4. Turn the key switch to ON.
5. Check that battery voltage is present in the red/white wire at multi-purpose buzzer.
5.1. If there is no battery voltage, check the 10-amp ATM fuse.
6. Set the Forward/Neutral/Reverse control (FNR) to R.
6.1. If the multi-purpose buzzer does not sound, check the multi-purpose buzzer limit switch.
7. Turn the key switch to OFF.
NOTE: Multi-purpose Buzzer Limit Switch: This is a continuity test.
The multi-purpose buzzer limit switch is located on the FNR. Red/white and orange wires are connected to it.
1. Disconnect the black wire from the multi-purpose buzzer.
2. Set the FNR to R.
3. Check for continuity between the black wire and ground.
3.1. If there is no continuity, replace the multi-purpose buzzer limit switch.
3.2. If there is continuity, go to step 4.
4. Set the FNR to F.
5. Check for continuity between the black wire and ground.
5.1. If there is continuity, replace the multi-purpose buzzer limit switch.
5.2. If there is no continuity, replace the multi-purpose buzzer.
Page 18-22 2020 Precedent,Villager 2 and 4 Maintenance and Service Manual