Club Car Carryall 1500 2016, Maintenance And Service Manual

Page: 376 / 436

19
Attachment Interface HYDRAULIC ATTACHMENT SYSTEM
4.3. For the auxiliary circuit, if equipped, turn the key switch to the OFF position and press the auxiliary hydraulic
switch to the right and then to left several times to relieve pressure.
5. Once pressure is relieved from the circuit(s) to be serviced, make sure the key switch is in the OFF position and
set the joystick ON/OFF switch to OFF.
ATTACHMENT INTERFACE
INSPECTION
Hand Lever
WARNING
• The pins must extend through the holes in attachment. Lever must be fully engaged in the locked
position. Failure to secure pins can allow attachment to come off and cause injury or death.
2
1
2
2220
Figure 19-1 Hand Lever
2221
Figure 19-2 Attachment Pins
1. Move the locking hand lever (1) to engage and disengage the pins (2) (Figure 19-1, Page 19-2) . The lever and
pins must move freely.
2. The pins (2) must extend through the holes in the attachment mounting frame (Figure 19-2, Page 19-2) . If the pin
does not extend through the hole, the attachment will be loose and can come off the attachment interface.
3. Inspect the linkages and pins for excessive wear or damage (Figure 19-3, Page 19-3) . Replace any parts that
are damaged, bent or missing. Keep all fasteners tight.
Page 19-2 2016 Carryall 1500/1700 and XRT 1550 Maintenance and Service Manual