Club Car Bobcat 2100 2004, Owner'S Manual

Page: 24 / 40

Storage
Page 22 2004 Pioneer 1200/Carryall 272/Turf 272/Bobcat 2100 Gasoline Vehicle Owner’s Manual (Europe)
6. To protect the engine, remove spark plug and pour 1/2 ounce (14.2 mL) of SAE 10 weight oil into the
engine through the spark plug hole. Rotate engine crankshaft by hand several times and then install the
spark plug.
7. Adjust tires to recommended tire pressure. See Vehicle Specifications on page 32.
8. Perform semiannual periodic lubrication. See Periodic Lubrication Schedule on page 26.
9. Thoroughly clean front body, rear body, seats, cargo bed, engine compartment, and underside of vehicle.
10. Do not engage the park brake. Chock the wheels to prevent the vehicle from rolling.
RETURNING THE STORED VEHICLE TO SERVICE
1. Restore fuel system to operation.
1.1. Remove plug from fuel tank vent.
1.2. Connect vent tube to fuel tank vent.
2. Connect battery cables, positive (+) cable first.
3. Completely open the fuel shut-off valve (Figure 11, Page 21). Make sure the valve is fully open. A par-
tially closed fuel shut-off valve (Figure 12, Page 22) combined with the use of the choke can result in a
fouled spark plug and engine failure.
4. Place the Forward/Reverse handle in the NEUTRAL position. Crank the engine until fuel is pumped into
the carburetor and fuel lines and the engine starts. Turn the engine off. See following NOTE.
NOTE: Due to the oil added to the engine in preparation for storage, engine may smoke excessively for a
short while when running it for the first time after storage.
5. Adjust tires to recommended tire pressure. See Vehicle Specifications on page 32.
6. Perform the Pre-Operation and Daily Safety Checklist on page 15.
Figure 12 Incorrect Fuel Shut-off Valve Setting
VIEWED FROM SELECTOR
SIDE OF VALVE
PARTIALLY CLOSED
POSITION