Club Car 2006 DS Golf, Owner'S Manual

Page: 18 / 44

Pre-Operation and Daily Safety Checklist
Page 14 2006 Gold Standard Electric Vehicle Owner’s Manual
the vehicle. When the switch is in the TOW position, power to the vehicle electrical components is turned off
and the vehicle will not operate.
See following NOTE.
NOTE: After placing the Tow/Run switch in the TOW position, allow 10 seconds to elapse before switching
back to the RUN position.
After placing the Tow/Run switch in the RUN position, allow 10 seconds to elapse before operating
the vehicle.
The Tow/Run switch should be placed in the TOW position under the following conditions:
• Before Towing the Vehicle: Place the Tow/Run switch in the TOW position to disable all motor braking
functions, thus preventing possible damage that could occur to the vehicle or electrical components if
the vehicle is towed while the zero speed detect motor braking function is operating.
• Before Disconnecting or Connecting Battery Cables: Place the Tow/Run switch in the TOW posi-
tion to turn off power to the vehicle electrical system, thus preventing severe arcing and possible bat-
tery explosion as the battery cables are disconnected.
• For Long-Term Storage: Place the Tow/Run switch in the TOW position to turn off power to the vehi-
cle electrical system, thus preventing vehicle electrical components from discharging the batteries.
PRE-OPERATION AND DAILY SAFETY CHECKLIST
Each Club Car vehicle has been thoroughly inspected and adjusted at the factory; however, upon receiving
your new vehicle(s), you should become familiar with its controls, indicators, and operation. Carefully inspect
each vehicle to ensure that it is in proper working condition before accepting delivery.
Use the following checklist as a guide to inspect the vehicle. This checklist should be used daily to ensure that
the vehicle is in proper working condition and in conjunction with the Periodic Service Schedule on page 22.
Any problems should be corrected by a Club Car distributor/dealer or a trained technician.
• General: All the parts should be in place and properly installed. Be sure that all nuts, bolts, and screws
are tight.
• Safety and information decals: Check to ensure that all safety and information decals are in place.
See pages 4 and 5.
• Tires: Check for proper tire pressure. Visually inspect tires for wear, damage, and proper inflation on a
daily basis. See Specifications – DS Golf, DS 4-Passenger, and Handyman on page 33 or Specifi-
cations – Lynx 4-passenger and Box Bed Vehicle on page 34.
Figure 10 Tow/Run Switch
F
TOW
RUN
WAR
NING