www.cls-led.com
www.cls-led.com
3
4
The CLS Miriam GII can be installed by using
the mounting hole. Drill a hole to secure it
in the wall, floor, ceiling, etc. Drill a second
hole for the power wire and DMX cables.
Adjust the Miriam GII to the
preferred position by turning the
unit towards or away from the wall.
Connect the DMX cables to the DMX
controller, then put the power wire in the
earthed socket
The CLS Miriam GII is ready to use.
270
o
OFF
FCN
CH
%
1
2
3
4
5
6
270
o
OFF
FCN
CH
%
1
2
3
4
5
6
This section shows how to install the CLS Miriam GII.
INSTALLATION
The CLS Miriam GII is controlled via DMX512. To configure the address,
use the up and down buttons on the back of the CLS Miriam GII.
When the address is selected, the Miriam GII stores it automatically.
Next time the Miriam GII is powered on, the address is restored to
the address that was previously selected. The range of possible addresses
is 1-510. The CLS Miriam GII uses 3 DMX-channels to control colour
and intensity.
DMX-channel [N]:
RED
DMX-channel [N+1]: GREEN
DMX-channel [N+2]: BLUE
Note: N is the address that is selected
Master/Slave operation
The CLS Miriam GII can operate in a master/slave mode. The CLS Miriam GII has a built-in programme with
two speed selections P1 (fast) and P2 (slow). To select the master/slave mode, press the up or down button
on the back of the CLS Miriam GII. This selection is also stored. When the master slave/mode is selected,
there can only be one master. All other Miriam GIIs must be addressed as slave on address 1.
Test mode operation
To check if all colours work properly, it is possible to put the CLS Miriam GII in a test mode. Simply adjust the
address to 0. The Miriam GII will show all colours in a stepping order. Make sure to reset the address when
testing is done.
MEASUREMENTS
ø 225 mm
310 mm
IN
OUT
100~240 VAC
Button 1
Display
DMX in / out
Button 2
DMX OPERATION
