Clover HDV043, Instruction Manual

Page: 31 / 117

31 | P a g e
ranging from 169.254.1.0 ~ 169.254.254.255 then you have been assigned pseudorandom IP
address and it is a indication that there are no DHCP service available for DVR device.
Static IP setting is used when your ISP (Internet Service Provider) gives routable IP they are
call Public IPv4 address. They are IP address that points to the DVR unit without relying on
DHCP service. In situation such as this case you may configure IP address as recommended
by ISP. Often times Static IP is still used with class A, B, or C address. In those cases, you
must point to IP addresses that are not in lease range of the DHCP scope (IP address not
issued by DHCP services but must be in same Subnet and Gateway IP). Users tend to use
this method when certain IP address out of DHCP scope where particular IPs are configured
to use NAT, IP forwarding, or DMZ (NAT, IP forwarding and DMZ are used in most router to
enable incoming traffic to specific IP addresses).
Step 2. Configure Port for incoming traffic. You must have NAT, IP forwarding or DMZ
configured in your router in order to allow in bound traffic to your network. And Port assign
to allow inbound traffic to local IP assign to DVR should be identical to Port configuration
with DVR. See figure below but your router configuration page might look different.
and DVR.
Figure 23 Port Forwarding Example
All above steps mentioned in Chapter 3. Quick Setup will ensure that you will have DVR
connect to Cameras, enabled recording and basic network configuration.