UNIT STATUS AND RECHARGING PROCEDURES
Note: Upon initial purchase, your PP15 should be charged for a minimum of 6 hours.
Unit Status Indication
Press the triangular Status/Power Button on the front of the unit to see the unit’s state
of charge. The unit’s state of charge status is indicated by three blue LEDs around the
Status Button, as follows:
1 Flashing Blue LED
Recharge Immediately
1 Solid Blue LED
30% State of Charge
2 Solid Blue LEDs
60% State of Charge
3 Solid Blue LEDs
100% State of Charge
It is recommended that the unit be at or near 100% state of charge when using as a
jump starter. This will greatly improve the odds of success.
Recharging Your PP15
There are two ways to charge your PP15, via the included AC adapter or the included
DC adapter.
Charging via the included AC adapter.
1. Connect the pin jack at the end of the AC adapter cord to the PP15 through the
input port marked “14V, 1A.”
2. Connect the male end of the AC adapter to the AC outlet.
3. Using this method, the unit will be brought to full charge automatically without
overcharging.
Charging via the included DC adapter.
1. Connect the pin jack at the end of the DC adapter cord to the PP15 through the
input port marked “14V, 1A.”
2. Connect the male end of the DC adapter to a vehicle power port.
3. Using this method, the unit will be brought to full charge automatically without
overcharging.
Note: The Blue Status LEDs will flash cumulatively to indicate charging progress, with
a single flashing LED indicating a significant amount of charging time is needed and
two solid and a single flashing LED indicate charging is almost complete.
