15
the table to align the guide. Then tighten it back.
5.3 General Advice For Cutting
•
Only tiles with max. dimensions of 15-3/4”x15-3/4”x1/4” (400x400x6mm) and
max. weight of 6-1/2 lbs (3kg) can be cut with the machine.
•
Before beginning work make sure tools are firmly seated!
•
Select the right Norton Diamond Blade as recommended by Norton Clipper which
depends on the material to be cut, and if cutting wet or dry.
•
Make sure the water tray contains enough water.
•
Set the guide-a-cut to the desired width of cut, using the two engraved
measurements to align it correctly.
•
Do not force on the motor. This machine is not designed for a continuous use.
6. Maintenance And Servicing
To ensure a long-term quality from the cutting with the CTC701, please follow the
maintenance plan below:
6.1 Maintenance Of The Machine
Always perform the maintenance of the machine with the machine isolated from the
electrical supply.
6.2 Lubrication
The CTC701 uses life-lubricated bearings. Therefore, you don’t need to lubricate the
machine at all.
