Allrecipes™ -in- APPLE PEELER
•
•
•
•
•
•
•
INSTRUCTIONS
•
•
•
•
TROUBLESHOOTING
•
•
PROBLEM – Can’t peel
SOLUTION – Three-pronged gripper fork must be
centered through corer/slicer blade as in diagram A
and peeling blade must be set as in diagram C
OR
Adjust blade (see diagram C) by increasing gap a
small amount at a time; if the gap is too big it will
gouge apple
PROBLEM – Fruit is not slicing
SOLUTION – Corer/slicer blade is on backwards
and must be turned around (See diagram B)
Release the groove clamp and pull crank handle all
the way back.
Pivot peeler-arm to the side and lock it in place with
the peeler lock.
Push apple firmly into three-pronged fork (either end
of apple will do). Center prongs through core.
Turn the crank until the apple comes in contact with
the blade. To adjust the depth at which the blade
peels the apple, loosen the wing nut on the peeler
blade and adjust the gap between peeling blade and
blade shelf lip. (See diagram C)
Remove apple core by releasing the groove clamp
•
OPTIONS
•
•
For peeling only, detach corer/slicer blade.
For slicing and coring without peeling, pivot peeler-
arm to the side and lock it in place with the peeler-
arm lock.
CLEANING
•
Hand wash with warm, soapy water. Rinse
thoroughly.
CAUTION
•
Exposed blades – handle with care
Allrecipes™ 3-in-1 Apple Peeler features extremely
sharp cutting surfaces. Use caution with the blades
and keep them out-of-reach of children at all times
Fast and easy apple preparation for snacks, pies,
sauces and more
Also great for potatoes, pears, radishes and more
Simultaneously cores, peels, and slices
Remove the core and slicing blade to only peel, and
pull back the peeler blade to just slice and core
Stainless steel blades for lasting durability
Powerful suction base securely locks to countertop
for hands-free stability
For best results always select firm and fresh fruit;
ASSEMBLY
•
•
•
Secure machine onto a clean, dry, sturdy surface such
as a counter or tabletop by pressing the lever on the
suction base.
Attach crank handle. Use a screwdriver to tighten.
Check alignment of the three-pronged fork and the
position of the corer/slicer blade. (See diagrams A & B)
CHANGING THE BLADE
•
Corer/Slicer Blade
1. When attaching this blade to the frame, make sure
the three-pronged fork is all the way forward by
releasing the groove clamp.
2. Fit and center corer/slicer blade over three-pronged
fork and support plate with the wing nut and hole
coring ring facing out, not toward the prongs.
(See diagram B)
•
•
Peeler Blade
1. Loosen wing nut to replace or adjust blade. Blade
can be adjusted for minimum to maximum peel
thickness. (See diagram C)
CRANK
HANDLE
GROOVE CLAMP
THREE-PRONGED
GRIPPER FORK
ADJUSTABLE
PEELER BLADE
CORER/SLICER
BLADE
SUCTION BASE
