Contender Series DVR
User Manual
6701 CLINTON ROAD • LOVES PARK, IL 61111 • 1-800-549-6393 (SUPPORT) • www.clintonelectronics.com
4
Chapter 1 – Installation
1.1 Connecting the Video Source
Figure 1 — Video input connectors.
Connect the coaxial cables from the video sources to the BNC Video In connectors.
1.2 Connecting the Loop Through Video
Figure 2 — Video Loop Through connectors.
If you would like to connect your video source to another device, you can use the Loop BNC connectors.
NOTE: The Loop BNC connectors are auto terminated. Do NOT connect a cable to the Loop BNC unless it
is connected to another terminated device because it will cause poor quality video.
1.3 Connecting the Monitor
Figure 3 — Video Out connectors.
Connect the monitor to Main, VGA, or S-Video connector.
Connect the spot monitor to the SPOT connector if required.
1.4 Connecting Alarms
Figure 4 — Alarm Input connector strips.
NOTE: To make connections on the Alarm Connector Strip, press and hold the button and insert the wire
in the hole above the button. After releasing the button, tug gently on the wire to make certain it is
connected. To disconnect a wire, press and hold the button below the wire and pull out the wire.
Summary of Contents for Contender CE-DVR16
Page 1: ......
