INSTALLATION AND USER MANUAL
HTM-24E
9
V0REV5ES1218
IMPORTANT: It is recommended to weld pipelines by oxyacetylene welding.
Welding is a critical step in the installation and to do it well ensures that the system will run
properly along its useful life.
Only expert staff should make this step by using proper tools and high quality materials.
Once panels are anchored, the next step consists on the installation of the liquid
distributor. Its function is to ensure the homogeneous refrigerant flow in the whole panel
installation.
Possible distributor scheme is shown in the next picture:
Install the distributor vertically, face upwards according to the picture.
IMPORTANT: To ensure the same flow of refrigerant in every panel and consequently take
advantage of the evaporation surface entirely; you should install the same tube length from the
distributor to every panel. If a pipe is too long for the length require, it must be rolled up.
Panels are supplied with two nuts at the inlet and outlet connection. The inlet to each panel is
1/4 inch diameter. The installer has to insert the nut into the copper pipe, flare the pipe and
then use the nut to fit it.
Repeat the procedure with the outlet connection using 3/ 8 inch copper pipe.
3/4’’
1/2 ‘’
1/4 ‘’
6
1/4 ‘’
6
1/4 ‘’
8
1/4 ‘’
8
3/8‘’
3/4’’
5
1/4 ‘’
4
1/4 ‘’
4
1/4 ‘’
4
1/4 ‘’
4
1/4 ‘’
4
3/8‘’
3/4’’
5
3/8‘’
3/4’’
4
1/4 ‘’
6
1/4 ‘’
6
1/4 ‘’
6
1/4 ‘’
6
1/4 ‘’
6
1/4 ‘’
6
1/4 ‘’
6
1/4 ‘’
6
1/4 ‘’
6
3/8‘’
3/4’’
6
1/4 ‘’
6
1/4 ‘’
6
1/4 ‘’
6
6
1/4 ‘’
1/4 ‘’
6
1/4 ‘’
6
HTM 20
HTM 30
HTM 36
HTM 24
HTM 12
HTM 16
1/2’’
1/2 ‘’
Summary of Contents for HTM EVI SERIES
