Climax Hybrid-Panel Series, User Manual

Page: 64 / 110

61
Sound Setting

Door Chime Setting : this function is available only when the attribute of Door Contact
(DC) and/or PIR detector (IR) is set as Door Chime .
The Control Panel sounds a Door Chime (Ding-Dong Sound) while the DC and/or IR is
activated in Disarm / Full / Home / Entry mode.

Entry Delay Sound for Full Arm : this is for you to decide whether the Control Panel
sounds count-down beeps and volume of beep during the entry delay time in the full
arm mode.

Exit Delay Sound for Full Arm : this is for you to decide whether the Control Panel
sounds count-down beeps and volume of beep during the exit delay timer in the full arm
mode.

Entry Delay Sound for Home Arm : this is for you to decide whether the Control Panel
sounds count-down beeps and volume of beep during the entry delay time in the home
arm mode.

Exit Delay Sound for Home Arm : this is for you to decide whether the Control Panel
sounds count-down beeps and volume of beep during the exit delay timer in the home
arm mode.

Confirm Sound: this is for you to decide whether to turn off/or adjust Control Panel
beeping sounds when changing Arm/Home Arm/Disarm mode.

Warning beep : this is for you to decide whether the Control Panel will sound a warning
beep whenever a fault condition has been detected and displayed. The warning beep
will be silenced after the Fault message has been read by the user. When a new fault
condition is detected, it will then again emit a warning beep every 30 sec.

Entry/ Exit Only Final Beeps: This is for you to determine when the Control Panel
should start warning beep during Entry or Exit countdown timer. For example, if the
setting is set to 5 seconds, the Control Panel will only stat warning beep during the last
5 seconds of Entry or Exit countdown timer. When set to Disable, the Control Panel will
sound warning beep during the entire Entry or Exit countdown timer.