Climax H&S TOOL SPEED FACER ODF100, Operating Manual

Page: 59 / 132

P/N 102615, Rev. 0 Page 41
8. Set the feed rate, referencing Section 3.4.7 on
page 37 and using the feed adjustment screw on
the feed box.
4.2.3 Configuring for the backfacing
attachment
The ODF Speed Facer can also be configured with the
optional backfacing attachment. This configuration
allows flange facing when there are obstructions run-
ning through the workpiece and also allows machining
of the backside of the bolting flange (see Figure 4-3).
F
IGURE
4-3. B
ACKFACING CONFIGURATION
(ODF80
SHOWN
)
Do the following to configure the machine for backfac-
ing:
1. Remove the bridge weldment from the
machine. Observe the posted masses and use
proper lifting and moving procedures, as
described in Section 3.2 on page 29.
2. Remove the radial slide assembly from the
bridge weldment and install it onto the backfac-
ing mount plate.
3. Relocate the motor to the bottom of the
machine.
4. Install the brace (see Figure 4-4).
F
IGURE
4-4. R
ELOCATED MOTOR AND BRACE LOCATION
(ODF80
SHOWN
)
5. Install the 1/4" (6.5 mm) thick backfacing
spacer under the backfacing bracket and onto
the machine and secure with the M12 x 50mm
screws. There are two positions in which the
angle mount weldment can be installed requir-
ing the use of two or three screws.
6. Install the backfacing brace onto the machine
with a M12 x 40mm screw but do not fully
tighten.
T
IP
:
The brace has multiple configurations for
various machine sizes and backfacing
configurations. It enhances the backfacing
rigidity. The ODF30 and ODF40 do not use the
brace.
7. On ODF50 and larger models: Install four M12 x
1.75 x 25mm fasteners in brace plate-2 then
slide brace plate-1 onto the fasteners using the
four non-tapped holes. Secure the brace plates
to the angle mount weldment by tightening the
fasteners.
8. If the machine is mounted in the vertical posi-
tion: Reposition the counterweight to oppose
the backfacing attachment by shifting it
counter-clockwise to the next series of three
holes (see Figure 4-3 on page 41).
9. To reposition the feedbox from the radial slide
to the axial slide do the following:
BACKFACING
ATTACHMENT
REPOSITIONED
COUNTERWEIGHT
BRACE
BACKFACING
MOUNT PLATE
RADIAL
SLIDE BASE
ANGLE MOUNT
WELDMENT
MOTOR ON
BOTTOM OF
MACHINE
ALTERNATIVE
MOUNTING LOCATION
FOR SMALLEST ID
MACHINING