3
Step 1.
Put Control Panel into Tag Learning Mode (Please refer to you Control Panel for details).
Step 2.
Place the tag near the Tag Reader Sensor to record a tag ID into the Control Panel.
Step 3.
The Tag Reader will emit 4 beeps to indicate a learning signal is sent to the Control Panel. If
Control Panel successfully received the tag ID, tag information will be displayed on the
Control Panel. If Control Panel fails to receive tag ID, Tag Reader’s Red LED will flash 5
times.
<NOTE>
If Tag Reader has not yet learned into the Control Panel, placing the tag near the Tag Reader
Sensor will emit 2 beeps indicating no transmission has been sent.
Operation:
After you complete learning the tag into the Control Panel, you can now switch the system to Arm,
Disarm Mode:
a) Disarm Mode Control:
Apply tag near Tag Reader Sensor, the Control Panel will
automatically switch to Disarm Mode, the Tag Reader will emit 2 beeps.
b) Arm Mode Control:
Press the Arm Button once, the Green LED will quickly flash for 5
seconds, then apply tag near Tag Reader Sensor, the Tag Reader will emit 1 long beep for
3 seconds to indicate arming success.
c) LED
flash:
If system is Armed, Green LED will light on for 3 seconds, after 3 seconds it will
continuously flash. When Disarmed, Green and Red LED will be off.
d) Alarm:
The Red LED continuous flash when alarm is triggered.
e)
Tamper:
When Tamper is triggered, the Tag Reader will transmit tamper alarm signal to the
Control Panel immediately and returns to power saving mode.
Changing Battery:
Step 1:
Remove the Tag Reader cover by losing the fixing screw.
Step 2:
Remove the old batteries.
Step 3:
Press Learn button to fully discharge.
Step 4:
Insert new batteries. The Tag Reader will emit one beep to indicate.
Step 5.
Press Learn button again to send low battery restore to Control Panel.
Step 6:
Fix the cover with the screw and mount back to its location.
Factory Default (Reset Learning Record):
Step 1:
Remove the cover by
losing the fixing screw.
Step 2:
Remove battery, then press the Learn Button and insert the batteries to power back on.
Step 3:
The Tag Reader will be removed from the Control Panel until it emits 3 beeps.
