CLIMAVENETA MICS FF, Installation, Operating And Service Manual

Page: 22 / 32

READING OF SENSOR VALUES
The following values may be displayed by pressing button
J for 1 sec and scrolling with button J or K:
Press button L to change a parameter
After having displayed the current value, use buttons J and
K to change it.
Then press button I to exit without saving the change or
button L to save the change.
Lastly press button I to return to the upper level menus
or to exit from the configuration menu.
MICS / MICS-N
20
English 07/07
IMPOSTAZIONE PARAMETRI SERVICE
A
SETTING THE SET POINTS
The factory Set Point settings are: cooling 12°C, heating
40°C.
To modify the set points, proceed as follows:
- Press button L for 5 sec. to access the main parameters
window.
- Use button J or K to scroll to the “parameters R” sub-
menu.
Press button L to access the “parameters R” submenu
and use button J or K to scroll the accessible parame-
ters of this menu:
r01 COOL set point °C 12
r02 COOL C1/C2 ON/OFF differential °C 3
r03 HEAT set point °C 40
r04 HEAT C1/C2 ON/OFF differential °C 3
LIST OF ACCESSIBLE PARAMETERS
Parameter Description Unit of measure Factory set point
Note: when setting the parameters the COMPRESSOR and HEATER LEDs will flash alternating with the DEFROST LED.
HSW8
HSW8
HSW8
HSW8
HSW8
HSW8
b01
water outlet temperature
°C
b02
water inlet temperature
°C
b04 high pressure value
b09 low pressure value
LIST OF ACCESSIBLE PARAMETERS
Parameter Description Unit of measure